Takagi 에러코드Takagi error codes
15개 코드 · 1개 제품군15 codes · 1 categories
🔥보일러·온수기Boilers & Water Heaters 15
031DIP스위치 설정 오류Incorrect DIP switch setting.101"991"(불완전연소) 경고Abnormal Combustion (lockout is imminent). A warning that the air-fuel ratio for combustion is gas rich. The heater will continue to operate, but a shutdown is imminent if the problem is not resolved.111점화 실패Ignition failure. The water heater will not fire after three failed ignition attempts.121화염 소실(Loss of flame)Flame loss. The heater lost the flame signal during a heating cycle and was not able to establish a flame after three failed ignition attempts.311서미스터 단선/단락Thermistor failure. Outlet thermistor failure (240/340 models) / Heat Exchanger Thermistor Failure (540 models).391공연비(Air-fuel) 로드 고장Air-Fuel Ratio Rod Failure. No flame is detected by the Air-Fuel Ratio (AFR) rod.510메인/가스 솔레노이드밸브 이상Abnormal Main Gas Solenoid Valve (MV). A fault in the main solenoid gas valve (MV) circuit.611팬모터 고장Abnormal Fan Motor. Fan motor fault.701컴퓨터보드(PCB) 고장Computer Board Fault / Proportional Gas Valve Fault.711가스솔레노이드밸브 구동회로 고장High Limit Switch / Overheat Cutoff Fuse Circuit is Compromised. On power-up the computer checks the gas valve, high limit and Overheat Cutoff Fuse (OHCF) circuits; if any is compromised this code appears. (Table 2 symptom: 'Gas solenoid valve drive circuit failure'.)721허위 화염 감지False Flame Detection. A false flame was detected by the system during start up; no flames should have been present, so the system stopped the ignition process.741본체↔리모컨 통신 이상Remote Control Problem. Miscommunication between water heater and remote controller.751본체↔온도컨트롤러 통신 이상Temperature Controller Problem. Miscommunication between water heater and temperature controller (Indoor model only).941배기온도 이상Abnormal Exhaust Temperature (Indoor models only). The exhaust temperature exceeded limits and the heater was not able to reduce it, forcing the exhaust high limit switch to trip and shut down the burners.991불완전연소Abnormal Combustion. Imperfect combustion, which can be caused by insufficient intake air or exhaust obstructions.