앱 다운로드Get the app
Hoshizaki

Hoshizaki 에러코드Hoshizaki error codes

8개 코드 · 1개 제품군8 codes · 1 categories

🧊냉장고Refrigerators 8

E1제빙(프리즈) 사이클 백업타이머 종료 — 제빙이 제한시간(IM-500SAB 기준 45분) 내 완료되지 않음. 급수밸브·핫가스밸브 누설, 펌프·팽창밸브·냉매부족·압축기 점검Freeze Cycle Backup Timer. Freeze cycle backup timer (Control Board Setting 6) has terminated. 50 min. after water tank starts to close in preceding harvest cycle, unit stops if the evaporator temperature is above 32F (0C).E2탈빙(하베스트) 사이클 백업타이머 종료 — 탈빙 개시 후 30분 내 종료온도 미도달. 서미스터 단선·핫가스밸브·냉매부족·압축기 점검Harvest Cycle Backup Timer. Harvest cycle backup timer has terminated. 30 min. after water tank starts to open in harvest cycle, unit stops if harvest cycle termination temperature (Control Board Setting 1) has not been reached.E3워터탱크 열림 백업타이머 초과 — 액추에이터 모터 위치센서가 3분 내 완전 열림을 감지 못함(화면에는 'EE'로 표시, E3은 에러로그 코드). 액추에이터 모터·컨트롤보드 점검Water Tank Opening Backup Timer. 3-minute opening backup timer starts when water tank starts to open. If actuator motor's internal position sensor does not indicate water tank is fully open within 3 minutes, display shows "EE" and unit stops for 60 minutes.E4워터탱크 닫힘 백업타이머 초과 — 위치센서가 제한시간(IM-500SAB 기준 3분) 내 완전 닫힘을 감지 못함(화면 'EE', E4는 에러로그 코드). 액추에이터 모터·컨트롤보드 점검Water Tank Closing Backup Timer. 50-second closing backup timer starts when water tank starts to close. If actuator motor's internal position sensor does not indicate water tank is fully closed within 50 seconds, display shows "EE" and unit stops for 60 minutes.E5증발기 고온 이상 — 증발기 온도 60℃ 이상 5초 지속 시 정지. 탈빙 계통(핫가스밸브 고착·릴레이)·온수 유입·서미스터 단락 점검High Evaporator Temperature — unit stops if evaporator is 140F/60C or higher for 5 sec; check stuck HGV or CB relay, hot water entering, shorted thermistor (displayed as 'EE', logged as E5)E9응축기 서미스터 단선/단락(2초 지속) — 서미스터 교체 필요(해당 부품이 없는 모델에서는 발생 안 함)Condenser thermistor open or shorted for 2 sec — replace condenser thermistor (does not occur on models without one)EC컨트롤보드 이상(모델 데이터 IC 불량) — 컨트롤보드 교체 필요Control Board Error — model data IC defective; replace control board (displayed as 'EE', logged as EC)Ed증발기(큐브 컨트롤) 서미스터 단선/단락 — 서미스터 교체 필요Evaporator (cube control) thermistor open or shorted for 2 sec — replace evaporator thermistor (displayed as 'EE', logged as Ed)