Franke 에러코드Franke error codes
18개 코드 · 1개 제품군18 codes · 1 categories
🍳주방가전Kitchen Appliances 18
E2과열Corresponding cooking area switches off. Empty or unsuitable pan. Pan or ceramic glass surface temperature too high. Electronic component temperature too high.E3냄비/팬 부적합 또는 출력 초과Corresponding cooking area switches off. Unsuitable pan. The pan is losing its magnetic properties and may damage the induction hob.E4설정(구성) 오류 — 인덕션 모듈이 아직 구성되지 않아 해당 화구를 켤 수 없음Configuration error — the induction module is not configured yet; the cooking area cannot be activatedE5조작부(UI)와 인덕션 제너레이터 간 통신 없음 — 해당 화구 사용 불가. LIN 케이블·전원 케이블 불량 또는 제너레이터/필터 회로 내부 오류No communication between UI and induction generator; the cooking area cannot be activated. LIN cable or power cable faulty, or internal error in generator/filter circuitsE6전원 동기펄스(Mains-Sync-Pulse) 오류Hob does not switch on. Power supply voltage and/or frequency is out of range.E7터치컨트롤(TC) 내부 오류 — 모든 화구가 비활성화됨TC internal error — the cooking areas are deactivatedE8냉각팬 오류Cooking areas are turned off. Fan fault. Fan blocked by dust or fibres.E9화구 온도센서 오류 — 센서 회로 단선 또는 단락, 해당 화구 정지Cooking area temperature sensor error — sensor circuit open or short-circuited; the corresponding cooking area is offEA터치컨트롤(TC) 내부 오류 — 모든 화구 정지, 제너레이터 교체 필요TC internal error — the cooking areas are off; replace the generatorEH온도센서 고착 — 화구를 켠 뒤에도 온도 변화가 없어 해당 화구 정지Temperature sensor blocked — no temperature change detected after the cooking area is switched on; that area is offER03버튼 연속작동 감지 (지속음 동반), 10초 후 컨트롤 꺼짐Hob switches off after 10 sec. Continuous key activation detected. Water or pan placed on the control panel.ER20터치컨트롤(TC) 내부 오류 — 터치컨트롤 교체 필요TC (touch control) internal error — replace the TCER21과열 — 온도제어가 85°C 초과를 감지. 75°C 아래로 식으면 해제Overheating — temperature control detected above 85C; clears once below 75CER22버튼 분석 결함, 3.5~7.5초 후 컨트롤 꺼짐Button analysis fault; the control shuts off after 3.5~7.5 sER31터치컨트롤(TC)과 인덕션 제너레이터의 설정값 불일치Inconsistency between the configuration of the TC and the induction generatorER36터치컨트롤(TC) 내부 오류 — TC 교체 필요TC internal error — replace the TCER47LIN 통신 오류(연결케이블 미접속/불량)LIN communication error (connecting cable unplugged/faulty)U400배선 오류/400V 과전압Overvoltage due to an incorrect electrical connection.